SpeedNeeds
SpeedNeeds Tool

Wheel & Tire Fitment Calculator

Compare the wheels and tires on your car now with the set you want to run. It works out the sizes, shows exactly how far each edge of the tire moves, and, if you feed it two tape measurements off your own car, tells you straight whether the new set clears, runs tight, or hits. Works on any car. It never guesses your clearances for you. Pick an axle, fill in both setups, then hit Calculate.

Lowering eats fender lip room fast. The verdicts below take this into account.

On the car now

Backspacing and offset are two ways of saying where the wheel sits. Give one, the tool works out the other.

The set you want to run

Measure mode: your car's real clearances (optional, and it is the whole point)

With the current setup on the car, at ride height, measure the gap from the tire to the nearest part on the inside, and from the tire to the fender lip on the outside. Feed those two numbers in and the tool projects the new set against your car, not a chart.

The comparison

Fill in both setups, then Calculate
On the car nowThe set you want
Tire——
Overall diameter——
Sidewall height——
Tire width——
Circumference——
Revolutions per mile——
Wheel——
Backspacing——
Offset——

What moves, and which way

  • Run the comparison and every edge movement shows up here in plain inches.

Fit verdicts from your measurements

Inside: tire to nearest part
—
needs your inside measurement above
Outside: tire to fender lip
—
needs your outside measurement above

Your plain-English read lands here after you run it.

Same series, other widths

Locking yourself to one sidewall series (a class rule, a look, a gearing target) fixes the tradeoff: on the same rim, wider in that series always means taller. This table follows the rim and series of the set you want.

Tire sizeDiameterTire width
Run the comparison and this fills in.

The deciding checks

  • Run the comparison and the checks for your setup land here.
How the math works
Tire size math: sidewall height is the width times the series (aspect) percentage. Diameter is the rim diameter plus two sidewalls. Circumference is pi times diameter, and revolutions per mile is 63,360 inches of road divided by that circumference.

Wheel math: a wheel's true overall width is about an inch more than its named width, bead seat to bead seat versus lip to lip. Offset is how far the mounting face sits from the wheel's centerline: offset in inches equals backspacing minus half the overall width. Positive offset tucks the wheel in, negative pushes it out.

Edge movement: the tire is treated as centered on the wheel, which is how tires sit. Move the wheel in with more backspacing and both tire edges move in with it. Go wider and each edge moves out by half the added width, before the wheel position is counted. The verdicts then spend those movements against the clearances you measured on your own car. No car database, no guessed numbers.

A taller tire also lifts the top of the tire closer to the top of the wheel arch and makes the speedometer read slow. For gearing math after a tire change, use the Tire Size Change tool linked below.

A calculator plans the job. The tape measure on your car finishes it. Stop guessing. Prove the next move. SPEEDNEEDS.NET

Get new drops in your inbox

Read the Privacy Policy.