SpeedNeeds logo
SpeedNeeds Tool

Shock Travel & Bottoming Checker

This checks your available bump, available droop, whether the shock is trying to bottom out or top out, and whether your bump stop is doing its job. No auto‑calc: you control it.

Real talk: If your shock bottoms before the bump stop, you’re using the shock as a bump stop. That’s how shafts get bent and mounts get ripped.
Tool displays in your chosen units. Internally it converts to inches for the math.
Recommended: 0.25 in (≈6 mm). This is cushion away from hard stop.
This tool checks shock limits only. Coilovers also need spring bind clearance.
From the spec sheet. Fully collapsed length.
From the spec sheet. Fully extended length.
Measure center‑to‑center (or same points) with the car sitting how you drive it.
Jack/compress until the bump stop touches (or until you hit your intended full bump point).
Let the suspension hang (or your intended max droop) and measure again.
Distance from bump stop to contact at ride height. If you don’t know, leave blank.
How much the bump stop can compress before it turns into a brick. If unknown, leave blank.
Doesn’t affect math. Helps you remember what you measured.
Tip: after you change numbers, hit Calculate again. Nothing updates automatically.
Available bump travel
--
Ride → full bump
Available droop travel
--
Ride → full droop
Shock compression clearance
--
Full bump vs compressed limit
Shock extension clearance
--
Full droop vs extended limit
Bottoming risk indicator
--

Enter your numbers and hit Calculate.

Beginner’s quick guide (how to measure without fancy tools)
  1. Ride height length: car on the ground, normal load, measure the shock length (center‑to‑center).
  2. Full bump length: jack/compress the suspension until the bump stop just touches (or until your intended “max bump”). Measure again.
  3. Full droop length: let it hang or drop to your intended max. Measure again.
  4. Spec sheet lengths: compressed and extended lengths come from the shock manufacturer.
Safety: secure the vehicle on stands, keep hands clear of pinch points, and don’t trust a jack by itself.
Notes & formulas (what the tool is doing)
  • Bump travel = RideLen − BumpLen
  • Droop travel = DroopLen − RideLen
  • Compression clearance = BumpLen − CompressedLen
  • Extension clearance = ExtendedLen − DroopLen
  • Margin check: clearances should be ≥ your Safety margin (default 0.25").
  • Bump stop engagement (optional): if you entered bump stop gap + squish, we check if the bump stop would bottom.
If you want the shock to be protected, the bump stop should engage before the shock hits its compressed limit.
Disclaimer (read this before you bet your car on it)
This tool is an estimate helper. Real suspensions have bushing deflection, chassis flex, tire growth, and parts that move in arcs. Verify with real-world clearance checks (and a witness mark or zip-tie on the shock shaft). You are responsible for safe installation and testing.
Measurements are estimates. Real suspensions move in arcs and flex. Verify with physical clearance checks, witness marks (zip-tie on the shaft), and controlled testing before hard driving.

Get new drops in your inbox

Read the Privacy Policy.