SpeedNeeds
SpeedNeeds Tool

Camshaft Sizer

Tell it what the car is and how you use it — the heads, the intake, the gear, and the transmission all get a vote. It sizes a cam range for the whole combo. It will never hand you a part number, because the right cam is the one that fits the whole car. Pick your combo, then hit Calculate. Load Example only fills fields and never auto-runs.

The heads are the ceiling. No cam can outrun heads that stop flowing.
Chop comes from overlap. Overlap costs idle vacuum and low-speed manners — that trade is priced in below.

Your cam range

Pick your combo, then Calculate
Duration @ .050 (intake)
—
degrees of crank rotation, intake lobe
Lobe Separation
—
set by the idle you picked
Lift direction
—
set by your heads

Your plain-English read lands here after you run it.

Watch-outs

  • Nothing flagged yet. Run the sizing and the traps in your combo show up here.

Before you buy — the four checks that decide it

  • Valve springs vs. lift. The springs on your heads have a lift limit. The cam you buy has to fit under it, or the springs get swapped too.
  • Piston-to-valve clearance. Bigger cam, valves open further and longer. Clay the piston and measure — never assume it clears.
  • Pushrod length. A cam swap can change the geometry. Check pushrod length after the swap, not before you order.
  • Tune. Carb or EFI, the tune has to match the new cam. A cam the tune does not know about will idle and drive like a mistake.
What this is doing (the sizing)
Duration is how long the valve stays open, counted in degrees of crank rotation at .050 in. of lift. Bigger duration moves the power higher in the rev range and gives back low-end manners to get it.

Lobe separation is the gap between the intake and exhaust lobes, in degrees. Narrower means more overlap — both valves open at once — and overlap is where the chop comes from. It is also where idle vacuum goes.

The sizing starts from a band for what the car is for, then moves it for your intake, gear, transmission, and heads. A single plane, deep gears, a stick, and strong heads all let a combo use more cam. Highway gears and a stock converter take cam away. Then the heads get the last word: the top of the range is capped at what your heads can actually feed.

Assumes a V8 with a hydraulic cam. Overhead-cam and variable-timing engines play by different rules.

A range is a starting point, not a part number. The cam card and your own measurements finish the job. Stop guessing. Prove the next move. — SPEEDNEEDS.NET

Get new drops in your inbox

Read the Privacy Policy.