SpeedNeeds logo
SpeedNeeds Tool

Tire Size Change → Speedometer Correction

Enter old and new tire sizes. We’ll compute sidewall height, tire diameter, and revs/mile for both—then give you the correction factor and your actual speed at any speedometer reading.

Old Tire

Sidewall Height
—
inches
Tire Diameter
—
inches
Revs per Mile
—
rev/mi

New Tire

Sidewall Height
—
inches
Tire Diameter
—
inches
Revs per Mile
—
rev/mi
Correction Factor
—
new D ÷ old D
Actual Speed
—
mph
% Difference
—
(Actual – Speedometer) ÷ Speedometer × 100
Math & Notes
  • Sidewall (in) = (section_width ÷ 25.4) × (aspect ÷ 100)
  • Tire Diameter (in) = 2 × sidewall + wheel_diameter
  • Revs/Mile = 63360 ÷ (π × tire_diameter)
  • Correction Factor = new_diameter ÷ old_diameter
  • Actual Speed = speedometer_reading × correction_factor
Bigger tires ⇒ correction factor > 1 ⇒ actual speed is higher than indicated. Smaller tires ⇒ factor < 1.
SpeedNeeds logo
SpeedNeeds Tool

Final Drive Ratio Estimator (Bonus)

Estimate axle final drive from engine RPM, vehicle speed (mph), tire diameter (in), and transmission gear ratio.

Use measured loaded tire diameter for best accuracy.
Estimated Final Drive
—
Back‑check @ inputs
—
mph from RPM with estimated FD
Notes
This Final Drive Ratio Estimator calculates an approximate gear ratio based on engine RPM, vehicle speed, tire diameter (in inches), and transmission gear ratio. For best accuracy, use the actual measured tire diameter under load rather than the advertised size. This tool is ideal for verifying existing gear ratios or estimating needs for performance, cruise RPM, or drivability tuning.
Formula: FD = RPM × (π × D) ÷ (gear × mph × 1056). Equivalent constant form: FD ≈ (RPM × D) ÷ (gear × mph × 336). Assumes no driveline slip.

Related Tool

Tire size and final drive also set your cruise RPM. The Vehicle Speed & RPM Calculator shows engine RPM at any road speed, and road speed at any RPM, from the same numbers.

Get new drops in your inbox

Read the Privacy Policy.