SpeedNeeds / Tool Bundles

Electrical & Ignition Bundle

Stop guessing at electrical faults. Run the numbers first.

Five SpeedNeeds tools covering ignition headroom, spark energy, and voltage drop, the three places electrical problems hide, in one purchase.

Founding
$29
Regular
$39
One payment. No subscription. See the offer
Inside the Bundle01 / 04
The Voltage Drop Verdict Calculator: a 0.68 volt drop measured on the ignition coil power feed under load, and the verdict card reading FAIL, excessive drop
Voltage Drop Verdict Calculator Run on a coil power feed: 0.68 volts dropped under load against a 0.50 volt limit. The verdict reads FAIL, and the tool names the next test to run.

01 / The problem

The fault was never in the part.

Electrical faults eat weekends because they do not look like anything. The car cranks slow, or the spark goes weak at high rpm, or a new part goes in and the fault stays, because the fault was never in the part. It was in the feed, the ground, or the margin the system never had.

So the parts cannon comes out. A coil, then a module, then a cable, each one bought on a guess. The money leaves either way. The only question is whether the numbers got run before the parts got ordered.

These five tools are the numbers, run before the order.

02 / How it works

Run the numbers before the order.

Each tool takes one electrical question and works it to an answer you can act on: whether the ignition has anything in reserve, what the spark actually needs, and where voltage is being lost between the battery and the part, at rest, cranking, and running.

You measure first, and the part you buy is the part the numbers pointed at.

  • Anything in reserve
  • What the spark actually needs
  • Where voltage is being lost

03 / Inside

What’s inside.

Five tools, all of them in the bundle.

The five tools

  • Ignition Headroom Calculator. checks the time budget for every spark. At your rpm, is there enough time per spark event to charge the coil, or recharge the CDI box, with anything left over? It answers in time, the margin you have or the margin you are out of.
  • Spark Energy Requirement Calculator. estimates how hard your spark is to jump, from compression, boost, nitrous, plug gap, and fuel, and rates the risk. A high reading points at the gap, a voltage problem, or an ignition that needs to grow, before you buy parts on a guess.
  • Voltage Drop Test Procedure. the test itself on one printable page. What you need, the five steps, the drop limits by circuit, what a pass, high, or fail reading means, and what a fail does not prove.
  • Voltage Drop Verdict Calculator. two readings in, verdict out. Pick the circuit, enter the drop you measured under load, and get a plain PASS, HIGH, or FAIL, what the result proves, what it does not prove, and the next test to run.
  • Run / Crank Voltage Drop Calculator. totals the drop on the feed side and the ground side of a loaded circuit, figures the voltage the part actually gets, and checks each side against the run or crank targets.

04 / A closer look

What the numbers tell you.

The Ignition Headroom Calculator on an eight cylinder engine at 6,500 rpm: headroom minus 30 percent, status out of headroom

02 / Headroom

Is there anything in reserve?

The V8 in this screen is checked at 6,500 rpm: 2.31 milliseconds a spark event against 3 milliseconds the coil needs. Headroom reads minus 30 percent, out of headroom, and the tool says what fixes it: fix voltage drop, reduce spark demand, or upgrade the ignition path.

The Run / Crank Voltage Drop Calculator on a cranking circuit: 0.42 volts total drop, 9.98 volts delivered, overall result PASS

03 / Run and crank

What does the starter actually get?

The cranking circuit in this screen drops 0.42 volts in total and delivers 9.98 volts to the starter, inside its targets on the positive side and the ground side both.

The Spark Energy Requirement Calculator: spark demand index 1.09, risk level moderate, on a 10.5 to 1 engine at 6,500 rpm

04 / Spark energy

How hard is the spark to jump?

The same engine at 6,500 rpm: a spark demand index of 1.09 and a moderate risk read, figured from compression, gap, and fuel before a coil gets bought.

Walkthrough

Watch all five tools run on one V8.

The narrated walkthrough is below, running all five tools on one V8 at 6,500 rpm. The screens above are the tools themselves, run on real numbers.

The honest limit, stated plain: these tools work the numbers you give them. They do not reach into the car, and a reading taken at the wrong point is a wrong reading no calculator can fix. The procedure tool exists because where you measure is half the answer.

05 / Delivery

Buy it. It is yours.

  1. Buy through My Access.

    Sign in or create a free My Access account. Stripe handles the secure checkout.

  2. Open the bundle.

    After payment, open it from My Access, signed in to your account.

  3. Keep using it.

    Open it through My Access whenever you need it. One payment, and it stays yours, no subscription.

06 / Questions

Before you pay.

Is this a subscription?

No. One payment. The five tools sit in your My Access account and you open them when you need them.

Why a bundle instead of one tool at a time?

Because the faults do not stay in one lane. A weak spark complaint can be a demand problem, a time problem, or voltage lost on the way to the coil. The five tools are sold as one bundle because the chase crosses all of them, and the bundle is the whole electrical side of it.

Do the tools work on my setup?

They run in your browser through My Access, on the numbers from your own car. There is no car specific version to pick.

What if it is not for me?

The refund terms are on the Terms of Sale and Refund Policy pages. The bundle invents no terms of its own.

07 / The price

One payment.
Yours to keep.

The first 100 founding buyers pay $29. After those 100 purchases, the one-time price is $39.

Founding price
$29
Regular price
$39

Electrical & Ignition Bundle · $29 founding · $39 regular

Buy the Electrical & Ignition Bundle

Secure checkout via Stripe through My Access. Tax is figured at checkout. You see the full total before you pay. Access granted after payment.

Also inside All-20 All-Access, the whole shelf in one purchase.