SpeedNeedsSpeedNeeds Diagnostics
Worksheet Relay Control Hold Proof

Relay-Hold Worksheet

Capture relay terminal identity, command state, coil/control behavior, and load-side readings through pull-in and hold. A relay click is an observation—not proof that the command, coil path, contacts, and load feed stayed valid.

Core rule

Verify the terminal map first, then prove command, coil differential, and load-side output during the same hold event.

Use this when a relay pulls in and drops out, chatters, will not stay energized, appears commanded but does not carry the load, or when you need to separate a control-side problem from a contact/feed/load-side problem.

Electrical safety

Do not jumper an unidentified relay terminal or bypass a high-current circuit blindly. Use current service information, fused test leads where appropriate, correct meter settings, and a known reference. Never resistance-test a powered circuit.

1Vehicle / Job Information

Start clean

2Relay / Terminal Identification

Map it first

Do not assume every relay uses the same cavity numbering or control strategy. Record the actual diagram and terminal function before interpreting voltage.

30

Common / Feed

85

Coil Side A

86

Coil Side B

87

Normally Open Output

87a

Normally Closed

3Command & Hold Condition

Lock the event
Do not stop at the click: a mechanical click does not prove the coil is being held at adequate differential voltage, the contacts are carrying current, or the load feed remains valid.

4Electrical Capture — OFF, Pull-In, Hold / Fault

Same reference

Use the same meter reference and same terminal map for all three captures. Record the voltage across the coil directly when possible; terminal-to-ground readings alone can mislead on high-side, low-side, PWM, or floating control circuits.

A — Commanded OFF Baseline

Before pull-in. Establish feed and resting control state.

B — Initial Pull-In

Capture immediately as the relay is commanded ON.

C — Held State / Fault Point

Capture while the relay should still be ON, especially at dropout or chatter.

5Controlled Change / Repeat Test

One move

6Drift / Safety / Evidence Quality Check

Trust the setup
Evidence stop: If terminal identity, command condition, measurement reference, or load connection is uncertain, mark the worksheet inconclusive. Do not condemn the relay or control module from ambiguous voltage.

7Final Result / Conclusion

Evidence-owned

Choose the result that the measurements support. These are routing categories, not automatic component condemnations.

8Boundary / Next Action

Route clean
Boundary: This worksheet proves the relay command/hold event and the quality of the electrical capture. It does not replace the vehicle wiring diagram, terminal-specific service information, driver strategy, load specifications, current limits, or safe bypass procedures.

Get new drops in your inbox

Read the Privacy Policy.

Educational diagnostic worksheet. Use professional judgment, current service information, and safe procedures.