SpeedNeedsSpeedNeeds Diagnostics
Worksheet Leak Evidence Repeat Spot

Parked Fluid Spot Evidence Logger

Record what the spot actually proves—when it appeared, where it landed, whether it repeats, and where the wet trail leads—before naming the fluid or failed part.

Core rule

A spot proves fluid reached the ground. It does not prove the fluid source, leak rate, or failed component until the condition repeats and the wettest point is traced.

Use this after a new parked spot, suspected leak, or unexplained residue under the vehicle. Start on a clean, dry surface when possible and preserve comparable parking conditions for the recheck.

Safety / contamination warning

Do not crawl under an unsupported vehicle, touch hot exhaust or rotating parts, contact unknown chemicals bare-handed, or taste fluid. Treat fuel, brake fluid, coolant, battery electrolyte, and unknown fluid as hazardous.

1Vehicle / Job Information

Start clean

2Parking Condition Lock

Control the setup

Record the condition that produced the spot. A repeat check is weak if the parking surface, vehicle angle, heat state, weather, or operating history changed.

3First Spot Capture

Record before cleanup
Freshness / Surface State
Amount / Pattern
Location rule: Record where the fluid landed relative to the vehicle. Do not name the source from the ground spot alone; shields, crossmembers, airflow, gravity, and rotating parts can move fluid.

4Fluid Traits and Blot Evidence

Hypothesis only

Use gloves and a clean white absorbent card when safe. Color and odor can narrow the field, but age, contamination, additives, lighting, and mixed fluids can make them lie.

Do not taste fluid. Unknown fluids can be toxic, corrosive, flammable, contaminated, or absorbed through skin. Stop and contain the area if fuel, brake fluid, battery electrolyte, or an active stream is suspected.

5Repeatability / Controlled Recheck

Comparable conditions

Clean or cover the original landing area, mark the vehicle position, then repeat the parking condition. A new spot on a clean witness surface is stronger evidence than an old stain getting wet again.

Recheck Cycle 1

Recheck Cycle 2

Recheck Cycle 3

Repeatability Result

6Wettest-Point Trace

Trace, do not guess
Support the vehicle correctly before any under-vehicle inspection. Keep clear of hot exhaust, belts, fans, pressurized systems, moving driveline parts, and unstable lifting points. Do not run the vehicle in an enclosed space.

Start at the ground landing point and inspect upward and upstream. Record the lowest wet component, then follow the trail to the highest, freshest, or most upstream wet point you can defend.

Proof boundary: The wettest or most upstream point is a source candidate. It is not automatic proof that the nearby component failed; fluid may come from a seal, fitting, hose, vent, spill, service residue, or a source above the visible point.

7Drift, Safety, and Evidence-Quality Check

Gate the conclusion
Possible False Evidence / Contamination
Urgent / Unsafe Evidence

8Final Logger Result

No guessing
Capture Outcome
Boundary: This logger records parked-spot evidence and trace quality. It does not identify a failed component by color, odor, landing location, or one wet surface. Use current service information, safe lifting procedures, fluid-level checks, and system-specific testing before repair decisions.

Get new drops in your inbox

Read the Privacy Policy.