SpeedNeedsSpeedNeeds Diagnostics
Worksheet Ignition Feed Loaded Voltage Drop

Coil Feed Voltage-Drop Log Worksheet

Prove whether the ignition-coil power feed is losing voltage under the condition that matters, isolate the feed segment if loss is excessive, and document the retest without confusing static voltage with loaded circuit integrity.

Core rule

A coil-feed voltage reading is only useful when the circuit condition and load are known. Compare source voltage and coil-feed voltage under the same operating event.

Use this when coil supply voltage is questioned during crank, idle, loaded running, heat soak, intermittent misfire, no-start, or after a repair to the fuse, relay, splice, connector, or feed wiring.

Safety / evidence gate

Confirm the power-feed terminal from current service information before probing. Ignition circuits can contain high-energy primary switching and high secondary voltage. Backprobe safely, avoid shorting terminals, and do not treat a control/driver terminal as the feed circuit.

1Vehicle / Job Information

Start clean

2Circuit / Test Condition Lock

Know what you are measuring

Lock the exact circuit and test condition before comparing numbers. Do not mix readings from different operating states and call the difference circuit loss.

Proof boundary: Key-on static voltage can look normal through a high-resistance connection. The useful question is how much feed voltage is lost while the circuit is actually being asked to work.

3Loaded Coil-Feed Voltage-Drop Log

Same event, two voltages

Enter source voltage and coil-feed voltage from the same operating event. Calculated drop is the absolute difference between the two readings. Compare only to current service information or a validated known-good circuit.

Capture 1Baseline / crank event
Capture 2Running baseline
Capture 3Raised-load check
Capture 4Fault-state capture
Capture 5Additional controlled event
Capture 6Post-repair / verification
Calculated drop = |source voltage − coil-feed voltage|. If you directly measure across a circuit segment, record that reading in Section 4 instead of substituting it into these source/feed fields.

4Feed-Side Segment Isolation

Find where the loss lives

Use direct loaded voltage-drop measurements across individual feed segments after excessive total feed loss is proven. The circuit must be carrying the intended load during each comparison.

Segment 1Power distribution path
Segment 2Narrow the loss
Segment 3Narrow the loss
Segment 4Final feed segment
Do not over-call the evidence: An excessive feed-side drop proves loss in the tested path under that condition. It does not by itself prove the ignition coil is failed, nor does it evaluate the coil control/driver or ground architecture unless those circuits were separately tested.

5Repair / Change / Matched Retest

Before vs after

Before repair

After repair

6Drift / Safety / Evidence-Quality Check

Catch false proof

Check anything that could make the voltage comparison look better or worse without the feed path actually changing.

Capture quality: If source and feed voltage were not simultaneous, the repeated events must be close enough to be meaningfully comparable. Cranking speed, battery state, charging control, and load can move the baseline.

7Final Result / Conclusion

No parts cannon

8Boundary / Next Action

Route by proof
Boundary: This worksheet proves or clears voltage loss in the tested ignition-coil feed path under the documented condition. It does not condemn a coil, PCM/ignition driver, ground path, trigger circuit, secondary ignition component, or mechanical/fuel cause without separate evidence.

Get new drops in your inbox

Read the Privacy Policy.