SpeedNeeds logo
SpeedNeeds Tool

Spring Rate vs Corner Weight

This estimates required spring rate from your corner weight and suspension leverage (motion ratio). Choose either a target ride frequency (more intuitive) or a target wheel rate (if you already speak that language). Nothing calculates until you hit Calculate.

If you have scales, use corners. If not, the split mode is a legit first pass.
These are treated as “sprung-ish” weight unless you adjust the unsprung % below.

Math is the same. This only changes the “reality check” warnings.
Wheel rate uses MR². Wheel rate ≈ spring rate × MR².
Angle correction uses cos²(angle) (simple, practical).
Quick sanity lever. If you don’t know, leave it.
Internal math still converts correctly for frequency using mass.
Street cars are often ~1.0–1.5 Hz; sports cars ~1.25–1.75 Hz.
“Flat ride” often runs rear ~10–20% higher than front.

Results

Front spring rate (avg)
--
--
Rear spring rate (avg)
--
--
Wheel rate (F / R)
--
Effective stiffness at the tire
Ride frequency (F / R)
--
Undamped corner frequency
Sanity flag (front)
--
--
Sanity flag (rear)
--
--
Sprung weight used (F / R)
--
Corner weight minus unsprung %
Reality checks
--
Stuff that will wreck your result
Next step checklist
  1. Pick the closest real spring size (springs come in steps).
  2. Confirm you have enough bump + droop travel at ride height.
  3. Re-check motion ratio if anything feels “way off.”
  4. Shock valving and bump stops decide whether this rides good or rides hateful.

Physics used: f = (1/2π) √(k/m) → k = (2πf)² m.

What this tool is doing

1) Estimate sprung weight (corner weight minus a quick unsprung %).

2) If you choose frequency mode, compute wheel rate from frequency + mass using k = (2πf)² m.

3) Convert wheel rate to spring rate with motion ratio and spring angle:

wheel rate ≈ spring rate × MR² × cos²(angle)

That MR² term is why moving a spring/shock a little bit can change rate a lot.

How to measure motion ratio
  • Travel method (best): move the wheel 1.00" and measure spring compression. MR = wheel / spring.
  • Geometry method: on many arms, MR ≈ d1/d2 (pivot→spring divided by pivot→ball joint).

If you accidentally use spring/wheel instead of wheel/spring, your result will be way wrong. Double-check definition.

Safety / reality checks
  • Too soft: bottoms out, rubs tires, rides the bumpstops, feels sloppy.
  • Too stiff: harsh ride, less grip on rough roads, parts take a beating.
  • Sanity flags are based on commonly cited frequency ranges for street vs performance vs race.

Get new drops in your inbox

Read the Privacy Policy.