- Pick your trigger system and fill in the wear/noise categories honestly.
- Hit Calculate to get an estimated scatter range.
- If you have a measured number, compare it to the estimate. If the measured number is much worse, you have a real problem to chase.
SpeedNeeds Tool
Timing Scatter Estimator
Timing scatter is how much the actual spark timing jitters around the commanded value. This tool estimates scatter from common mechanical and signal contributors: distributor wear, timing chain slack, sensor noise, and voltage stability. No auto-calc.
Pick the RPM where you see the worst jitter with a timing light or logs.
Distributor systems are more vulnerable to mechanical scatter.
Used only for advice context.
Chain lash shows up as spark jitter, especially with distributor drive.
If you can feel wobble, it is already a problem.
Noise can create false edges and jitter timing.
Voltage instability can distort trigger thresholds and ECU behavior.
If you measured +/- degrees with a light or logs, enter it for compare.
Tool outputs peak-to-peak and +/-.
Not used in math. Copy/paste friendly.
Estimated scatter (+/-)
-
degrees around commanded timing
Estimated scatter (peak-to-peak)
-
total swing (deg)
Rating
-
-
Next move
-
-
How to use this (quick)
Notes and formulas
This tool uses a weighted contributor model (not a physics simulator). Each category adds a degrees-of-scatter contribution. Distributor systems get extra sensitivity to chain slack and distributor wear.
Base scatter (deg +/-):
crank trigger / OEM = 0.5
distributor = 1.0
Contributors (deg +/- added):
chain: tight 0.2, normal 0.6, loose 1.2
dist: na 0.0, tight 0.3, some 0.8, bad 1.6
sensor: clean 0.2, ok 0.6, noisy 1.2
volt: stable 0.1, some 0.4, bad 0.9
Distributor sensitivity multiplier:
if trigger = distributor:
(chain + dist) contributions * 1.25
Total (deg +/-):
pm = base + chain + dist + sensor + volt (with multiplier where noted)
Peak-to-peak:
pp = 2 * pm
Rating (peak-to-peak):
<= 2 deg = tight
2-6 deg = usable
6-10 deg = sloppy
> 10 deg = bad
Stay in the loop
Get new drops in your inbox
New QTS builds, tools, and garage stories — straight to your inbox. No spam. Unsubscribe anytime.
Read the Privacy Policy.