SpeedNeeds logo
SpeedNeeds Tool

Ignition Keep-Alive / Run-On Fault Identifier

Post-test pattern matcher. Answer the observations below and hit Calculate. Output is a fault class (not a repair plan).

1) Ignition power stays ON after key OFF
Observation: ignition feed remains present after the key is OFF.
2) Engine run-on / attempts to fire
Observation: engine continues to run or attempts to fire when it should be OFF.
3) Pulling the ignition relay stops it
Observation: removing the ignition relay stops the keep-alive/run-on condition.
4) Alternator unplug changes it
Observation: unplugging the alternator changes or stops the condition.
5) Aftermarket ignition/accessory influence
Observation: disconnecting an aftermarket ignition-related device changes or stops the condition.
Most likely fault class
--
--
Confidence
--
--
Key indicators matched
--
--
Runner-up (if close)
--
--
Notes & Formulas

Scope: This tool does not tell you what to replace. It flags the most common fault class behind an ignition keep-alive/run-on pattern after a FAIL upstream.

Inputs (Yes/No):

  • Q1 ignition power remains after key OFF
  • Q2 engine continues to run or attempts to fire
  • Q3 removing ignition relay stops the condition
  • Q4 unplugging alternator changes/stops the condition
  • Q5 disconnecting aftermarket ignition/accessory changes/stops the condition

Pattern scoring: Each answer adds points to a fault class. Highest score wins. Confidence is based on score separation.

score = sum(weight_i) per class
confidence = HIGH if (top - second) >= 4 and top >= 7
confidence = MED if (top - second) >= 2 and top >= 5
confidence = LOW otherwise (tie or weak separation)

Fault class definitions (plain language):

  • Welded ignition relay contacts: relay contact pair behaves like it is stuck closed, keeping IGN powered.
  • Alternator backfeed: charge circuit energizes the ignition feed when it should be dead (classic run-on pattern).
  • Shared-circuit backfeed: a parallel circuit feeds IGN through shared wiring/splices/loads.
  • Aftermarket miswire: added device ties IGN/RUN to constant power or creates an unintended feed path.

Related QTS (optional): If this points to a keep-alive/run-on pattern, a dedicated power-feed stability test may help confirm the behavior under the exact conditions that produced the FAIL.

Placeholder: [QTS-POWR-XXXX] (if/when created)

Get new drops in your inbox

Read the Privacy Policy.