SpeedNeeds logo
SpeedNeeds Tool

Ignition Cutout Pattern Identifier

This tool helps you label the cutout pattern so you do not prove the wrong thing in the wrong state. Fill what you actually observed. Then hit Calculate.

Choose the dominant feel. Do not average two different events.
Duration separates ignition breakdown vs power/logic drop.
If you can force it, you can test it.
Fluttering usually tracks real RPM instability (misfire), not signal loss.
Key-cycle and cooldown are strong tells. Do not ignore them.
A sync/RPM code changes the lane. A comm/reset code changes it harder.
If you did not check, say that. Do not assume.
Stable fuel with a hard cut pushes you back toward ignition/power/logic.
Primary lane
--
--
Secondary lanes to keep in play
--
--
What to capture next
--
--
Quick next checks
--
--
Help: how to observe a cutout pattern without guessing
  • Pick one event. Do not mix cruise hiccups with WOT breakup.
  • Tach flutter usually means real RPM instability (misfire), not a missing RPM signal.
  • If key-cycle fixes it, note that. If cooldown fixes it, note that.
  • When possible, confirm spark presence during the event (inline tester, scope, or a logging channel).
  • If fuel pressure is unknown, log it once. One clean data point beats a week of part swapping.
Notes and formulas: how this tool decides lanes

This is decision-support, not a diagnosis. The mapping below is the logic used by the tool.

  • Tach drops to zero instantly + hard cut = reference/primary signal loss OR power/ground interruption.
  • Tach flutter during breakup = misfire-style instability (secondary ignition breakdown stays high on the list).
  • Key-cycle required = module/driver protection, PCM reset, or a latch event (do not ignore).
  • Cooldown required = heat-related module/coil driver failure, wiring expansion, or sensor failure under temp.
  • Fuel stable during event reduces fuel-supply likelihood (but does not eliminate injector control issues).

Get new drops in your inbox

Read the Privacy Policy.