SpeedNeeds logo
SpeedNeeds Tool

Residual Fuel Pressure Decay Tool v1.0

Capture rail pressure vs time after shutdown and interpret the decay pattern (sealed system vs leak-style behavior).

Enter at least 2 data points. Time is minutes after shutdown (0 = right at key-off). Pressures must be non-negative.
First point should be near shutdown if possible.
Early drop helps separate patterns.
Optional.
Optional.
Optional tail point.
Total time (min)
—
Total pressure drop
—
Average decay rate
—
Early vs tail ratio
—
Early segment rate
—
Tail segment rate
—
Pattern hint (non-diagnostic)
—
Notes & Formulas

Inputs:

  • Pressure units: psi or kPa. Tool math uses your selected units (no unit conversion inside the math).
  • Time (min): minutes after shutdown. Enter points in increasing time order (0, 2, 5, 10, ...).
  • Minimum time window: optional guardrail. If your last point is under this window, the tool will warn you to capture longer data.
  • Stabilized tail band: optional comparison band for the tail segment rate (units/min). Smaller tail rate suggests the system is holding residual pressure.

Math used (frozen):

  • Total time: T = t_last - t_first
  • Total drop: D = p_first - p_last
  • Average decay rate: R_avg = D / T (units per minute)
  • Early segment rate: R_early = (p1 - p2) / (t2 - t1) using the first two valid points
  • Tail segment rate: R_tail = (p_(n-1) - p_n) / (t_n - t_(n-1)) using the last two valid points
  • Early vs tail ratio: Ratio = R_early / max(R_tail, tiny) where tiny = 0.000001 to avoid divide-by-zero

Interpretation (pattern bands, not a verdict):

  • Normal sealed behavior: small average rate + tail rate within your stabilized band.
  • Steady decay: early and tail rates are similar (ratio near 1). This can be seen with leakage paths that stay open over time.
  • Fast early drop, then slows: ratio is high (early much larger than tail). This is often associated with bleed-back style behavior.

Related SpeedNeeds explainer: Residual fuel pressure leakdown

Related QTS (conditional): If your decay pattern looks like steady loss, it may be useful to compare it against QTS-FUEL-C1 language. If the loss is mostly early and then stabilizes, it may be useful to compare it against QTS-FUEL-C2.

Get new drops in your inbox

Read the Privacy Policy.