SpeedNeeds logo
SpeedNeeds Tool

Prime vs Hold Pressure Comparator

Compares prime peak, crank, running pressure, and post-shutdown hold to interpret fuel control-side patterns. Version v1.0

Peak during key-on prime window.
Pressure while cranking (not running).
Stable pressure at warm idle or steady state.
If provided, tool computes vacuum-equivalent psi.
Time from engine-off to hold reading.
Rail pressure at the time above.
Prime-to-run drop (psi)
—
Vacuum equivalent (psi)
—
Run-to-hold drop (psi)
—
Decay rate (psi/min)
—
Computed details: Crank-to-run delta: — psi | Hold percent of run: —%
How to read the results (non-diagnostic patterns)

Prime-to-run drop is the observed "reference effect" when prime peak is higher than stabilized running pressure.

If you also entered vacuum, Vacuum equivalent converts inHg to psi so you can compare magnitude. Matching magnitude is common in vacuum-referenced setups, but it varies by system.

Run-to-hold drop and Decay rate help you separate fast loss from slow loss. Use this to support QTS decision gates, not as a standalone verdict.

Notes & Formulas

Inputs:

  • Prime peak rail pressure (psi), crank rail pressure (psi), running stabilized rail pressure (psi).
  • Optional manifold vacuum (inHg) at the same moment as the stabilized pressure.
  • Hold reading: minutes after shutdown (min) and rail pressure at that time (psi).

Edge cases:

  • If any required value is missing or invalid, the tool stops and alerts (no partial results).
  • If minutes after shutdown is 0, decay rate cannot be computed.
  • Vacuum is optional. If blank, vacuum-equivalent psi stays blank.

Frozen math (exact):

  • Prime-to-run drop (psi) = prime_psi - run_psi
  • Crank-to-run delta (psi) = crank_psi - run_psi
  • Vacuum equivalent (psi) = abs(vac_inhg) * 0.491154
  • Run-to-hold drop (psi) = run_psi - hold_psi
  • Hold percent of run (%) = (hold_psi / run_psi) * 100
  • Decay rate (psi/min) = (run_psi - hold_psi) / hold_min

Related QTS: If you are already running a containment-loss workflow, this comparator can support interpretation for QTS-FUEL-C2 and QTS-FUEL-C3. If you need the QTS link targets wired later, use the pending format: https://speedneeds.net/qts-pending/?qts=QTS-FUEL-C2

Get new drops in your inbox

Read the Privacy Policy.