SpeedNeeds logo
SpeedNeeds Tool

Injector Voltage Drop Logger

Log injector feed voltage against your source voltage, then spot the weak leg, average drop, and spread across the set.

Battery or injector feed source used as your reference point.
Used to build the active injector rows. Blank is not allowed for calculation.
Threshold used for PASS / WATCH / FAIL tagging.
Purely for your log. Does not change the math.
Optional note for this reading set.
Injector log
Injector Measured Feed Voltage (V) Drop (V) Drop % Status Notes
Average Drop
—
Across valid injector readings only.
Worst Injector
—
Highest voltage drop logged.
Spread
—
Difference between lowest and highest drop.
Rows Over Limit
—
Rows tagged FAIL using your threshold.
Notes & Formulas

Inputs: Source voltage is your reference point in volts. Cylinder / injector count builds the active row count for the current engine. Measured injector feed voltage is the actual voltage seen at each injector feed during the same test state. Max allowed drop is your chosen cutoff. Test state and notes are log-only fields.

Formula frozen in code: drop = sourceVoltage - measuredInjectorVoltage

Percent drop: dropPercent = (drop / sourceVoltage) × 100

Status logic: PASS when drop is less than or equal to the threshold, WATCH when drop is above the threshold but not more than 125% of it, FAIL when drop is greater than 125% of the threshold. Negative drop values are kept visible so bad reference picks or meter issues stand out.

Edge cases: Blank or invalid rows stay as an em dash and are excluded from summaries. A source voltage less than or equal to zero is rejected. Cylinder / injector count is required so row count cannot silently skew the outcome. The tool stops if count, source voltage, or threshold are missing or invalid. No auto-calc.

How to use it
  1. Enter your source voltage and your max allowed drop.
  2. Log each injector’s measured feed voltage in the table.
  3. Hit Calculate once the row data is in.
  4. Use the spread and worst row to spot whether you have one problem leg or the whole feed side dragging down.

Get new drops in your inbox

Read the Privacy Policy.