SpeedNeeds Tool

Injector Flow Rate (lb/hr vs cc/min)

Convert injector size between lb/hr and cc/min. This conversion depends on fuel density, so pick the fuel (or enter a custom density). No auto-calc—hit Calculate when you’re ready.

Enter the published injector size in the unit you selected.
Injector “lb/hr” is fuel-mass flow at a defined pressure and fuel.
If you’re using oxygenated blends, check your spec sheet.
lb/hr
—
Fuel mass per hour
cc/min
—
Fuel volume per minute
g/min
—
Intermediate mass flow
Density used
—
g/ml
Pressure scaling (optional)

If you’re comparing injector ratings at different reference pressures, flow scales approximately with the square root of pressure ratio: Flow₂ = Flow₁ × √(ΔP₂/ΔP₁). This assumes the same injector and the same fuel.

Use injector rating pressure (often 43.5 or 58 psi).
For manifold-referenced systems, use differential across injector.
Scaled lb/hr @ P2
—
From your input value
Scaled cc/min @ P2
—
From your input value
Multiplier
—
√(P2/P1)
Note
—
Differential pressure matters
Help

Why are there two “injector sizes”?
lb/hr is a mass flow number, while cc/min is volume flow. Converting between them requires fuel density.

Why does pressure matter?
Injector “flow rate” is only meaningful at a stated differential pressure across the injector. If the reference pressure changes, the number changes.

Want the deeper breakdown? Read: Injector Flow Rate (lb/hr vs cc/min).

Notes & formulas

Inputs

  • Injector flow value (lb/hr or cc/min)
  • Fuel density (g/ml) from preset fuel or custom
  • Optional pressure scaling: P1 and P2 (psi)

Core conversion math (frozen)

g/min = (lb/hr × 453.59237) ÷ 60
cc/min = (g/min) ÷ (density g/ml)
lb/hr = (cc/min × density g/ml) × (60 ÷ 453.59237)

Pressure scaling (frozen)

Flow₂ = Flow₁ × √(P2/P1)

Edge cases: blank, zero, or non-numeric inputs stop the calculation and show an alert. Outputs never “guess.”

Get new drops in your inbox

Read the Privacy Policy.