SpeedNeeds logo
SpeedNeeds Tool

Fuel Pressure Snapshot Logger

Log your pressure snapshots at Prime, Crank, and Run. Then capture a Hold reading after a timed interval. Use this as a clean record and a pattern check. Print it when you're done.

Snapshot taken right after key-on prime.
Snapshot while cranking (starter engaged).
Snapshot once it is running and stabilized.
Snapshot after the hold interval ends.
Type it, or use the built-in hold timer (Calculate starts/stops).
Keep it short. This prints.
Hold timer: Idle
Prime - Crank delta
--
Crank - Run delta
--
Run - Hold drop
--
Hold drop rate
--
Snapshot summary
--
Tip: Use your browser Print. This tool formats clean on paper.
Notes & formulas
Inputs
  • Prime, Crank, Run, Hold are pressure snapshots in psi.
  • Hold time is the elapsed time between Run and Hold snapshots (seconds).
Outputs
  • Prime - Crank delta = Prime psi minus Crank psi
  • Crank - Run delta = Crank psi minus Run psi
  • Run - Hold drop = Run psi minus Hold psi
  • Drop rate = (Run psi minus Hold psi) / Hold seconds
Hold timer behavior
  • Click Calculate once to start the hold timer (requires Run pressure).
  • Click Calculate again to stop and auto-fill Hold seconds.
  • After you enter Hold pressure, click Calculate to compute outputs.
delta = A - B
drop_rate (psi/sec) = (run - hold) / seconds
Purpose of this tool
  • Capture one clean set of pressure numbers without guessing later.
  • Compare snapshots to spot a supply drop, weak prime, or pressure bleed-down pattern.
  • Optional hold timer is user-started (no auto-run).

Get new drops in your inbox

Read the Privacy Policy.