SpeedNeeds logo
SpeedNeeds Tool

Excessive Fuel Pressure Classifier

Compares measured rail pressure to base spec and a user-set tolerance, then returns pattern buckets for QTS-FUEL-C3. Version v1.0

Use the same test conditions as the base spec (as close as practical).
Your known spec / target for that setup.
Required. This tool will not classify without your tolerance.
Just tells the tool how the reading was taken.
If you measured connected vs disconnected, enter the change magnitude.
Used only for pattern wording. No effect on math.
Delta vs base (psi)
—
Delta vs base (%)
—
Pattern bucket
—
What this supports (non-directive)
—
How this classifier stays honest

This tool does not declare a failed part. It turns a pressure reading into a repeatable comparison against your base spec and tolerance.

The "pattern bucket" is a neutral interpretation label you can use inside QTS-FUEL-C3 decision gates.

If you need strong separation between "regulation not controlling" vs "return path restricted", that comes from additional test evidence in the QTS lane, not from a single pressure number.

Notes & Formulas

Inputs: measured rail pressure (psi), base pressure spec (psi), allowed deviation (psi), reference state (connected/disconnected). Optional: observed reference effect (psi), pump condition note.

Required values gate: This tool will not classify unless measured, base, and tolerance are valid numbers and reference state is selected.

Frozen math (exact):

  • delta_psi = measured_psi - base_psi
  • delta_pct = (delta_psi / base_psi) * 100

Classification logic (exact):

  • If abs(delta_psi) <= tolerance_psi: bucket = "Within user tolerance"
  • If delta_psi > tolerance_psi: bucket = "Over base (by more than tolerance)"
  • If delta_psi < -tolerance_psi: bucket = "Under base (by more than tolerance)"

Interpretation helper (wording only, no extra math):

  • If bucket is over base and reference state is "connected": wording mentions "possible regulation/return control issue".
  • If bucket is over base and reference state is "disconnected": wording mentions "over-base even without reference influence".
  • If pump note is upgraded/stacked: wording adds a reminder that pump capability can amplify over-base pressure if return/regulation is not controlling.

Related QTS: If you are already running a pressure-regulation workflow, this tool can support interpretation for QTS-FUEL-C3. Pending format: https://speedneeds.net/qts-pending/?qts=QTS-FUEL-C3

Get new drops in your inbox

Read the Privacy Policy.