SpeedNeeds logo
SpeedNeeds Tool

Relay Backfeed / Latch Fault Identifier

Post-test pattern matcher. Answer the observations below and hit Calculate. Output is a fault class (not a repair plan).

1) Latch after command removed
Observation: the circuit stays powered after the relay command should be OFF.
2) Pulling the relay changes it
Observation: removing the relay stops the unintended power condition.
3) Aftermarket influence
Observation: unplugging an added/aftermarket device changes the condition.
4) Contact continuity with relay removed
Observation: there is continuity across the relay contact pair with the relay removed.
5) Suppression diode present on the relay coil
Observation: the relay has an internal/external coil diode (marked or visible).
Most likely fault class
--
--
Confidence
--
--
Key indicators matched
--
--
Runner-up (if close)
--
--
Notes & Formulas

Scope: This tool does not tell you what to replace. It flags the most common fault class behind a latch/backfeed pattern after a FAIL upstream.

Inputs (Yes/No):

  • Q1 latch observed after command removed
  • Q2 removing relay stops the condition
  • Q3 aftermarket device changes the condition
  • Q4 continuity across relay contacts with relay removed
  • Q5 relay coil diode is present

Pattern scoring: Each answer adds points to a fault class. Highest score wins. Confidence is based on score separation.

score = sum(weight_i) per class
confidence = HIGH if (top - second) >= 4 and top >= 7
confidence = MED if (top - second) >= 2 and top >= 5
confidence = LOW otherwise (tie or weak separation)

Fault class definitions (plain language):

  • Welded contacts: relay contact pair behaves like it is stuck closed.
  • Diode short: suppression diode across the coil becomes a short and drags or backfeeds the control side.
  • Harness backfeed: parallel circuit feeds power into the load side through shared wiring/splices.
  • Miswired aftermarket relay: added relay/accessory is wired such that it self-feeds or cross-feeds a circuit.

Related QTS: This tool is referenced by QTS-FUEL-A14 and QTS-FUEL-A15.

Get new drops in your inbox

Read the Privacy Policy.