SpeedNeeds logo
SpeedNeeds Tool

Velocity Stack Diameter Calculator

If your stacks are too small, you choke it. Too big, you lose signal and it gets lazy. This sizes stack inside diameter from your engine’s airflow and a target inlet velocity.

Cubic inches (V8: 302/331/347, LS: 346/376/408, etc.)
Use power peak, not idle.
Typically equals throttle bores or cylinders (ITBs: 8 on a V8).
0 for NA. If boosted, this approximates higher mass flow.
Rule of thumb: 275–325 ft/s at peak power is a solid “street fast” target.
Estimated total airflow
—
CFM @ inputs
Per-stack airflow
—
CFM / stack
Required stack I.D.
—
inches
Metric size
—
nearest common
Notes & formulas

What this is: A fast sizing pass for stack inside diameter based on flow and a target velocity. Real stacks have radiused entries and taper, so treat this like a baseline.

Airflow estimate: CFM = (CID × RPM × VE) ÷ 3456 × (1 + Boost/14.7)

Flow per stack: CFM_each = CFM ÷ stacks

Area from velocity: Convert to ft³/s: Q = CFM_each ÷ 60. Then Area(ft²) = Q ÷ V

Diameter: D(ft) = √(4×Area/π), then D(in) = D(ft) × 12

Sanity range: If your resulting velocity is >350 ft/s, you’re in choke territory. If it’s <200 ft/s, signal can get weak (lazy response).

Get new drops in your inbox

Read the Privacy Policy.