Reading a secondary ignition waveform

The secondary waveform is the spark's own testimony — demand, available voltage, and burn time, drawn in real time. Here is how to read what it is saying.

Conceptual definition

The secondary waveform is a voltage-against-time trace of the coil's output side — what the plug actually saw. It has three features, and each one testifies to a different fact.

The firing line is the tall spike: the voltage demanded to ionize the gap and start the spark. The spark line is the lower plateau after the spike: the burn itself, current flowing across the gap while the mixture lights. The available voltage is the system's ceiling — the most this coil and secondary path can deliver. Three features, three facts: what was demanded, what the burn looked like, what the system could give.

Why it varies

Firing-line height varies with demand — load, plug gap, mixture, boost. It should climb under load; that is normal.

Spark-line duration varies with mixture motion and composition — roughly 0.8–2.0 milliseconds is typical field convention. What matters is the shape: a clean, flat burn vs one that collapses, spikes, or rings.

The oscillations after the spark line are normal coil ring — leftover energy sloshing in the windings, not a fault.

Available voltage is a property of the system and barely moves with load. If the ceiling changes between tests, something in the system changed.

What it is not

The firing line is not a coil-health gauge. Tall means high demand, not a bad coil — the most common misread in ignition diagnostics.

The spark line is not 'spark strength' as a single number. Shape and duration carry the information; height alone says little.

A waveform is not a pass/fail stamp. It is read by comparison — the same cylinder at idle vs under the failing load. Comparison is the diagnosis; a single trace in isolation proves almost nothing.

Failure modes

How SpeedNeeds uses it

SpeedNeeds reads the waveform as three separate testimonies — demand from the firing line, the ceiling from available voltage, the burn from the spark line — and always compares the failing condition against the same cylinder's healthy baseline. Idle vs load, same cylinder, same pickup.

No single feature condemns a part. The pattern across all three features, confirmed under the failing condition, points at the system state — and then isolation tests name the part. The waveform accuses the system; the swap convicts the part.

Stop guessing. Prove the next move. Three features, one comparison, no shortcuts.

Caution and edge cases

Know your pickup. A capacitive pickup clamped on a plug wire and a direct secondary lead do not read identically — compare like with like.

Scope settings lie. The wrong timebase hides the spark line; the wrong voltage scale clips the firing line. Set the scope for what you are trying to see.

Compare the same cylinder sick vs healthy as the primary evidence — not cylinder-to-cylinder. Manufacturing spread between coils can fake a difference.

On smart coils with integrated drivers, a static primary-side resistance reading can mislead. The secondary waveform is the honest witness — trust it over the primary meter reading.

Closing clarity

Three features: what was demanded, what the burn looked like, what the system could give. Read all three, compare the same cylinder sick vs healthy, and let the pattern speak before you name a part.

The waveform doesn't guess. Neither should you.