Why spark dies under load

Load makes the spark work harder. When what the plug gap demands beats what the system can deliver, the spark dies — and the misfire only shows up when you ask for power.

Conceptual definition

Every spark plug gap needs a certain voltage to fire — the firing voltage, or kV demand. That demand is set by conditions in the cylinder: pressure, plug gap, mixture, temperature. The ignition system has a ceiling — the available voltage, the most the coil and secondary path can deliver.

As long as demand stays under the ceiling, the spark happens. When demand crosses the ceiling, there is no spark — the energy cannot get across the gap. The misfire is not the system being weak in general; it is demand beating supply at that moment, on that cylinder.

Why it varies

Demand moves; the ceiling barely does. What raises demand:

The ceiling — coil output capability and secondary-path integrity — is roughly fixed for a given system. The failure is almost always demand rising into a ceiling that did not move.

What it is not

A tall firing-voltage reading is not a bad coil. It is a measurement of demand — what the gap asked for. Coil health is judged by the ceiling and by whether the burn holds its shape, never by how tall the firing line got.

It is not 'weak spark' as a diagnosis. Weak spark is a symptom; demand beating available output is the mechanism. Naming the mechanism tells you which side to fix.

It is not fixed by a hotter coil alone when the demand side is the problem. A coil with a higher ceiling does nothing for worn plugs gapped twice as wide as spec — fix the demand side first.

Failure modes

How SpeedNeeds uses it

SpeedNeeds ignition diagnostics separate demand from available before naming anything. The secondary waveform is read in two parts: the firing line says what was demanded, the available voltage says what the system could give. The comparison — same cylinder, healthy vs failing condition — is the diagnosis.

A part is named only when a test isolates it: a demonstrated defect, or a swap the fault follows. Demand beating the ceiling is a verdict about the system state, not a parts order.

Stop guessing. Prove the next move. Measure what was asked, measure what was available, fix the side that's actually wrong.

Caution and edge cases

Don't read one waveform at idle and declare victory. Demand is lowest at idle; the failure happens under load. Test under the failing condition or you tested nothing.

A tall firing line at idle with a wide plug gap is normal demand, not a fault — context is everything.

Available voltage from a calibrated spark tester is a sanity check, not a pass/fail grade by itself. It confirms the ceiling; the waveform confirms the demand.

Temperature moves both demand and the ceiling. A system that passes cold can fail hot — retest at operating temperature when the symptom is heat-sensitive.

Closing clarity

The spark dies when the gap asks for more than the system can give. Find which side moved — demand up, or ceiling down — and fix that side.

Demand is the question. Available is the answer. The waveform is the witness.