Every crank starts as a single wire going hot. This page describes what that wire does, how the request travels from the key toward the starter, and why the switch contacts inside wear out over years of starts.
The ignition switch has one job in a no-crank: deliver battery power to the START wire while the key is held against the spring in START. Not in RUN. Not in ACC. The START position is momentary by design, spring-loaded, and the wire goes dead the instant the key falls back to RUN.
RUN is not START. A switch can feed RUN perfectly, with the dash lit and the blower running, and still have a worn START contact that never carries the crank request. The two positions use different contacts inside the same switch, and they age on their own schedules. The request exists only while the key is held in START.
From the switch, the request travels a short chain. Each link has its own job:
The chain comes in three layouts. Relay-driven, where the switch feeds a relay coil through the interlock, is the common modern layout. Solenoid-direct, where the switch drives the starter solenoid itself with no relay in between, lives on older vehicles. Module-mediated paths, found with push-button start and body modules, work differently again: the switch or button only talks to a module, and the module sends the request onward. The layout varies by vehicle and era, but the birth of the request is the same idea in all of them.
Inside the switch, small metal contacts meet every time the key turns. Each start asks the START contact to carry real current, and each meeting and parting leaves a tiny mark. Over years of starts, heat and small arcs pit and burn the contact faces. A worn contact can still pass a tiny trickle of current, which is why a tired switch can act confusing: enough gets through to make something click or glow, but not enough to pull a relay and crank the engine.
A tired switch often shows itself as a crank that comes and goes. The engine may crank when the key is wiggled or held just so, and stay silent at other times. Heat can play a part too: a worn contact may behave when cold and act up after a hot soak, then seem fine again the next morning. Those are felt symptoms of a contact that is wearing out, and they come from the simple fact that the request is born at one small set of contacts that has done this job thousands of times.
On keyed columns, the key cylinder and the electrical switch are two different parts joined by a rod or rack. The cylinder can turn, and feel perfectly normal doing it, while a worn, slipped, or cracked actuator never carries the electrical switch all the way into START. The key did its job; the message never arrived.
That split shows up in how the key feels. A sloppy, loose, or vague key feel points at the mechanical half of the assembly. A key that turns cleanly and lands in each position the way it should points away from it. The cylinder, the linkage, and the electrical switch are neighbors, not the same part, and each one can wear out on its own.
SpeedNeeds describes the starting system link by link, because each link has a different job and wears in a different way. The switch is the birth of the request: the moment the key is held in START, one wire goes hot and the rest of the chain gets its chance to work. Everything after that moment belongs to the next link in the chain.
One wire, hot only while the key is held in START. That is the entire birth of the crank request. The switch sends it, the interlock allows it, the relay and solenoid pass it along and grow it, and the starter does the work. A no-crank can be born at the switch when its contacts wear out, and it can just as easily come from any link that follows.
Stay in the loop
New QTS builds, tools, and garage stories — straight to your inbox. No spam. Unsubscribe anytime.
Read the Privacy Policy.