Battery internal resistance: what the voltage sag during crank is telling you
A battery can read 12.4 volts at rest and still be dead inside. The way its voltage sags while the starter cranks is the battery showing its internal resistance.
Conceptual definition
Every battery has internal resistance — the opposition its own plates, electrolyte, and internal connections offer to current flow. At rest, with no current flowing, that resistance is invisible: the posts read full voltage. But the moment the starter pulls hundreds of amps, Ohm's law does its work inside the case: terminal voltage sags by current times internal resistance (V = I × R). A healthy battery sags a little. A dying battery sags a lot. The sag is not a symptom of something else — it is the internal resistance, made visible.
This is why a voltmeter alone can lie to you. Twelve-point-four volts at rest proves the battery is charged. It proves nothing about whether the battery can deliver. Delivery is a current question, and current is where internal resistance lives.
Why it varies
Internal resistance is not a fixed number on a spec sheet — it is the sum of everything inside the case, and every part of it changes:
Plate condition. Sulfation — lead-sulfate crystals hardening on the plates from sitting discharged — is the big one. It insulates active material and drives resistance up steadily over months of neglect.
Electrolyte level. Plates exposed above the acid line stop participating. Less active plate area means higher resistance, and the damage from running dry is permanent.
Temperature. Cold thickens the chemistry: a battery at freezing has measurably higher internal resistance than the same battery at room temperature. This is normal physics, not failure. The same healthy battery is simply more resistive on a cold morning than on a warm afternoon.
State of charge. A discharged battery reads higher resistance than a charged one. This is the great mimicker: a battery at half charge sags under crank load much like a worn out battery does, even though its insides may still be sound.
Age and history. Every deep discharge, every summer of heat, every winter of short trips leaves its mark. Internal resistance is the odometer of a battery's life — it only ever trends one direction.
What it is not
Not the same as state of charge. A discharged battery sags under load too, but charging restores it. Internal resistance does not charge away, because it comes from worn plates and tired chemistry inside the case.
Not terminal or cable resistance. Corroded clamps and bad cables live outside the battery, in the wiring that connects it to the car. Internal resistance lives inside the case itself, in the plates, the acid, and the links between the cells.
Not what the dashboard voltmeter shows you. System voltage with the engine running is the alternator's doing. Internal resistance only shows itself when the battery does all the work on its own, above all during cranking.
Not a single universal number. A big diesel battery built to deliver heavy cranking current naturally has lower internal resistance than a small battery built for a compact car, and both can be perfectly healthy.
Not constant during the crank. The first fraction of a second includes inrush and quick chemical effects inside the battery, so the sag is deepest at the very start and then settles as cranking steadies.
Failure modes
Sulfation. The slow killer. Lead-sulfate crystals grow on discharged plates and harden until they no longer convert back. Resistance climbs month by month; the battery that started fine in October labors in January.
Plate shedding. Active material flakes off the grids and collects in the bottom of the case. Less plate, more resistance — and eventually a shed pile tall enough to short a cell.
Dried electrolyte. Heat and overcharging boil off water. Exposed plate area is dead plate area, and it does not come back with a top-up.
Inter-cell connection failure. The welded straps between cells crack from vibration and thermal cycling. The classic presentation is intermittent: fine on one crank, dead on the next, fine again — a resistance that makes and breaks.
Stratification. In batteries that sit without ever getting a full charge, acid concentrates at the bottom. The top of the plates works in weak acid, the bottom in strong — uneven, and higher resistance than either would be alone.
What the sag tells you
A strong battery holds its voltage up well while the starter pulls hard. A battery with high internal resistance cannot do that. Its voltage falls hard during cranking, the starter turns slowly or clicks, and lights can dim sharply, even though the same battery looked fine at rest a moment earlier.
That gap between resting voltage and cranking voltage is the heart of the idea. Resting voltage shows how much charge the battery holds. The sag during cranking shows how well the battery can deliver that charge when real work is asked of it. A battery can be good at the first and poor at the second, and that is why a battery that looks charged can still fail to start the car.
Caution and edge cases
Charge state shapes the sag. A battery that is low on charge sags under crank load much like a worn out battery, so a hard crank on a cold morning does not by itself prove the battery has worn out inside.
Cold is not failure. A battery on a freezing morning is naturally more resistive than the same battery on a mild day, so winter sluggishness can be plain physics rather than damage.
Faults can come and go. A cracked link between cells can carry current on one crank and lose it on the next, so a battery can start the car in the morning and refuse later the same day.
Two batteries share the work. On vehicles with two batteries wired together, the pair act as one supply, and one weak battery drags the whole pair down.
Closing clarity
Internal resistance is the battery's report card, written in physics instead of marketing. Rest voltage tells you what the battery holds. The sag during cranking tells you what the battery can deliver. A battery that reads fine at rest can still be worn out inside, and a battery that is simply low on charge can look worse than it is. Charge, temperature, and age all shape the picture, and the sag is where the battery's real condition shows.
Stay in the loop
Get new drops in your inbox
New QTS builds, tools, and garage stories — straight to your inbox. No spam. Unsubscribe anytime.